Two parts.
No screws.
Posts and panels, nothing else to assemble. Here is how a FenSteel fence goes up, step by step, with photos from a real job.
Measure and mark.
Measure your fence line and mark where the posts go. Each post sits 84 in (7 ft) center to center from the last one. Mark the spot for the next hole.
84 in center to center


Dig the post hole.
Dig the hole at the mark. Set the post in it and check that it sits 86 in outside to outside from the post before it.
86 in outside to outside

Set and level the posts.
Add water to the hole, then pour in the full bag of fast setting concrete, following the instructions on the bag. Right away, check that the post is plumb in both directions.
Before the concrete sets, confirm 86 in outside to outside at the top, the middle and the bottom of the posts.
Top 86 inMiddle 86 inBottom 86 in




Slide and interlock the panels.
Slide the first panel into both post channels. Before it goes all the way down, hook the next panel onto its interlocking edge.
Lower the connected panels together and repeat until all 10 panels are in. The stack starts high and works its way down to the ground.
10 panels a section
FenSteel crew · real footageFinal check.
Make sure every panel is fully interlocked, seated and lined up. Check the posts one more time and confirm the fence is solid.
That is one section. Repeat post by post down the line.

Rather have it installed?
We make the posts and panels. If you would rather not put it up yourself, we connect you with an independent installer who knows the system. Questions about your yard? Call or send us a note.